SITE CONTENTS 

     Home

     Getting Ready

     Construction

      Paint

      Final Assembly

      Internet Resources

Please send your comments
and suggestions to:

Email Me

Copyright © 2010 by
Randy Pflanzer
Technology Professionals Consortium
All rights reserved

Plating and Cleaning

     While the body is at the painter, and the frame is at the powder coater, I took the time clean up and either polish, paint, or chrome all the parts that I had previously removed.  This way when everything re-converges back in my hangar, I can go to town on the assembly.  This is a shot of the parts that I had chrome plated.

     Here's my collection of cleaned and painted parts laid out on the floor and ready to be bolted on.

     I picked up the body from the painter and carefully brought it home on the body buck.  It turned out very nice and I am quite happy with the way it turned out.

     Here's a nose on shot in the sun so you can see the ghost stripes.

     The first step on the body is to install a stainless steel firewall over the fiberglass firewall.  I'm doing this because I like the look of it and it will provide better protection.  It's not really necessary, but hey, I'm not going to get on the road until Spring anyway so why not do it.  Above are all the cardboard templates for the various pieces that make up the entire firewall.  It will take 12 pieces riveted together to complete it.

     Here's a shot of the passenger side firewall components.  What I did was build on one part at a time, fit it to the firewall, and drill the mounting holes.  I went around from each side until they met in the middle.

     Here's the final version installed.  This took me about three weeks of solid work to get it finished. 

     While I am working on the body, I've also been re-assembling the frame components.  Here's a shot of the front-end all bolted up and ready for the engine.

     The rear of the car is almost done as well.  All that's needed in the fuel tank and it is ready for the body.

Wiring

     Before the body can be put back on the frame, I need to install the wiring harnesses.  My plan is to build my own harnesses that are customized for my specific car.  The first step is to figure out where the runs will be attached to the body and the frame.  After looking things over, I decided on the routes that are outlined above.  Next step is to go over the the frame and the body and measure the exact distances between all the branches in the wiring.  I then write these numbers down in a table and it gives me all the dimensions I need to construct a wiring tree.  Also depicted on the picture are two major wiring runs.  One contains wires for sensors and other sensitive wires that I want to keep away from the power wires.  The other run is for all the power wires.

     Using the dimensions from my wire table, I outlined the tree structure on a sheet of plywood.  At each junction and along long wire runs, I installed drywall screws.  I will use these screws to attach the wires to the tree with rubber bands.  I then string each wire using my wiring diagram as my guide.  As I string the wires, I slip them through the rubber bands.  Once they are all run, I tie the wires together using wax cord and then cover the bundles with Red plastic sheathing.

     Here's the tree for the power wires with a few of the wires attached.  There's a lot of heavy wires on this tree and it will be a challenge to get them all grouped and covered.

     Next, I will finish up the wire harnesses and get ready to mount them in the car.

Ford, Shelby and Cobra are registered trademarks of the
 Ford Motor Company. LS427 Roadster is a registered
trademark of Lone Star Classics.  Randy Pflanzer and Technology Professionals Consortium are
 not connected to the holders
 of  these trademarks in
any way.

"You will never be happy if you continue to search for what happiness consists of. You will never live if you are looking for the meaning of life."
- Albert Camus